Wings - Angelic by Fran Seiford

INSTRUCTIONS
  1. Fold an 8-1/2" X 5-1/2" panel of navy cardstock in half to form card base.
  2. Adhere a 5-1/4" X 4" panel of patterned cardstock to card front.
  3. Tear a strip of aqua cardstock about 1-1/2" wide and trim to 5-1/4" long.
  4. Emboss greeting in VersaMark and Sterling Silver Embossing Powder on strip as shown.
  5. Use palette knife to apply Regular Embossing Paste to edge of strip.
  6. Sprinkle wet paste with Crystal Glitter mix and shaved ice. Press gently. Allow to dry.
  7. Adhere strip to card front along right edge of patterned paper layer.
  8. Die cut three wings from white cardstock. "Fluff" the feathers with fingers, craft knife, or other tool.
  9. Apply wings with 3D Foam Squares.
  10. Die cut a heart from red cardstock. Apply with 3D Foam Square to bottom right corner.
Print Project

Also uses these supplies:

Navy, Red and Aqua Cardstock
Embossing Heat Tool
ZipDry™ Paper Glue by Beacon Adhesives®
3D Foam Squares by Scrapbook Adhesives™ by 3L®
Die Cutting Machine by Sizzix
 

If you've use this product in a project of yours, we'd love to see it! You can submit your step-by-step instructions and supplies used by clicking below.

Submit A Project