Angel Blessing by Louise Healy

INSTRUCTIONS
  1. Fold a 6" x 9 1/2" piece of Deep Indigo cardstock in half to form an A6 card, round the top two corners.
  2. Stamp the Angel Blessing on a 4 1/4" x 5 1/2" piece of white cardstock with Tuxedo Black ink, color with Copic markers.
  3. Use the ruler and pencil to draw a light line from the edges to the ribbon tail on the right and to the top of the ribbon on the left, trim away the paper around the ribbon.
  4. Trim the top edge and the two sides to be an 1/8" away from the dotted edge of the scalloped frame, round the corners.
  5. Stamp the Snowflakes on a 4 1/4" x 5 1/2" piece of the Powder Blue Vintage paper using Memento Danube Blue, round the top two corners and edge the piece with the blue ink.
  6. Cut a 4 3/8" x 5 5/8" piece of white, round top two corners, adhere to the card front, then adhere the Snowflake layer to it.
  7. Use glue with a fine tip to apply glue to the fur areas of the Angel's cape and hat, add Crystal Micro Glitter, add to the tops of the berries too, let dry.
  8. Place some Spoonful of Snow on the snowdrift areas of the image, heat from underneath to melt and set.
  9. Use foam tape to add the Angel Blessing to the card front.

Print Project

Also uses these supplies:

  • MG01 Crystal Micro Glitter
  • EJS02 Spoonful of Snow
  • My Colors Cardstock by My Mind's Eye (Deep Indigo)
  • Powder Blue Vintage Patterned Paper by BoBunny
  • Copic® Markers (B32, B34, B37, B60, BG90, BG93, BG96, E01, E35, E37, E51, E53, R39, R59, R85, W0, W4, W6, W8, Y00, Y26)
  • Memento™ Danube Blue Ink by Tsukineko®
  • Zutter 1/2" Corner Rounder
  • Ruler
  • Pencil
  • White Eraser
  • Foam Mounting Tape by 3M®
  • Dries Clear Craft Glue

If you've use this product in a project of yours, we'd love to see it! You can submit your step-by-step instructions and supplies used by clicking below.

Submit A Project